GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

Definition: When the ignition switch is in the RUN position, one of the following actions occurs:

    • The fasten-belts indicator lamp in the instrument cluster stays illuminated when the driver's seat belt is fastened.
    • The fasten-belts indicator lamp stays illuminated for more than 77 seconds when the driver's seat belt is unfastened.

The BCM sounds the fasten-seat-belt reminder chime for 4-8 seconds when the ignition switch is set to the RUN position when the driver's seat belt is unfastened.

1

Was the Body Control Module (BCM) System Check performed?

--

Go to Step 2

Go to Diagnostic System Check - Body Control System

2

  1. Disconnect the BCM connector C2.
  2. Turn the ignition switch to the RUN position.
  3. Observe the fasten-belt indicator.

Is the fasten-belt indicator off?

--

Go to Step 4

Go to Step 3

3

  1. Turn the ignition switch to the LOCK position.
  2. Disconnect the instrument cluster.
  3. Turn the ignition switch to the RUN position.
  4. Using a J 39200 digital multimeter (DMM), measure the voltage between the BCM harness connector C2 terminal D2 and ground.

Is the voltage measured less than the specified value?

2 V

Go to Step 5

Go to Step 6

4

Replace the BCM. Refer to Body Control Module Replacement in Body Control Systems.

Is the action complete?

--

Go to Step 7

--

5

The fasten-belts indicator lamp stays on due to a malfunction in the instrument cluster. Refer to Instrument Cluster System Check for the diagnosis and repair of the instrument cluster.

Is the repair complete?

--

Go to Step 7

--

6

Repair the short to B+ in CKT 529.

Is the repair complete?

--

Go to Step 7

--

7

  1. Turn the ignition switch to the LOCK position.
  2. Reinstall the connectors and the components which you removed.
  3. Turn the ignition switch to the RUN position for 6 seconds.
  4. Remove the BCM PRGRM fuse.
  5. Turn the ignition switch to the ACC position. The BCM sounds the chime several times equivalent to the BCM type which is installed on the vehicle.
  6. Within 1 second, turn the ignition switch from the ACC position to the LOCK position, then back to the ACC position. The BCM sounds any DTCs stored.

Are any BCM DTCs present?

--

Go to Diagnostic System Check - Body Control System

System OK