The inflatable restraint sensing and diagnostic module (SDM) contains sensing devices that converts vehicle velocity changes to electrical signals. The SDM processes the generated electrical signals and compares them to values stored in memory. When the generated signals exceed the stored values, the SDM performs additional signal processing and compares the generated signals to signals stored in memory. When 2 of the generated signals exceed the stored values, the SDM will cause current to flow through the inflator modules, deploying the inflator modules. DTC B0053 will set along with DTC B0051 when a deployment occurs while a circuit malfunction is present in any one of the deployment loops.

Ignition voltage is between 9-16 volts.

DTC B0053 is a latched code. You cannot clear a latched code. Replace the SDM after following the instructions.

DTC B0053 will be accompanied by another DTC, other than DTC B1000 and DTC B0051. Repair the malfunction causing the other DTCs before installing a new SDM.

Electrical Information Reference

1. Ignition OFF, inspect the vehicle for signs of inflator module or pretensioner deployment. Verify that the vehicle does not show any signs of inflator deployment.

⇒	If the vehicle displays any signs of inflator deployment go to Repairs and Inspections Required After a Collision .

2. Use a scan tool and observe the SIR DTC display, refer to Diagnostic Trouble Code (DTC) List - Vehicle . The scan tool should indicate DTC B0053 is not set.

⇒	If DTC B0053 is set then replace the SDM.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.