J 34028 Inner Tie Rod Wrench

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the engine protection shield, if equipped. Refer to Engine Protection Shield Replacement .
3. Remove the outer tie rod end. Refer to Tie Rod Replacement .



4. Remove the inner tie rod end using the J 34028 (2).

Important: Perform the following procedure before installing the new tie rod ends:

1. Remove all traces of the oil, grease, or other contaminents.
2. Clean the threads of the tie rod with denatured alcohol or the equivalent and allow to dry.
3. Apply red LOCTITE threadlocker, GM P/N 12345493 (Canadian P/N 10953488) to the threads of the inner tie rod.

Notice: Refer to Fastener Notice in the Preface section.




4. Install the inner tie rod to the relay rod.

Tighten
Using the J 34028 (2) tighten the tie rod to 100 N·m (74 lb ft).

5. Install the outer tie rod end. Refer to Tie Rod Replacement .
6. Install the engine protection shield, if equipped. Refer to Engine Protection Shield Replacement .
7. Lower the vehicle.
8. Verify the wheel alignment. Refer to Wheel Alignment Specifications .