Tools Required

J 5590 Crankshaft Gear Installer

1. Remove the engine front cover. Refer to Engine Front Cover Replacement .
2. Remove the reluctor ring from the crankshaft position sensor.

Notice: Failure to properly align the crankshaft position sensor reluctor ring may result in component damage and effect OBD II system performance.

Important: The reluctor ring is shaped like a dish.

The dish must face the engine front cover. Failure to do so will damage the front cover and the reluctor ring.
1. Install the reluctor ring to the crankshaft position sensor.

1.1.	Align the keyway on the reluctor ring with the crankshaft balancer key in the crankshaft.

1.2.	Use the J 5590 in order to push the reluctor ring onto the crankshaft until completely seated against the crankshaft sprocket.

2. Install the engine front cover. Refer to Engine Front Cover Replacement .