GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 GMC_Truck 🢒 2008 🢒 Acadia - AWD 🢒 Engine 🢒 Engine Controls and Fuel - 2.8L, 3.0L, 3.2L, or 3.6L 🢒 Ignition Coil Replacement - Bank 1

Removal Procedure

    Object Number: 1926984 Size: SH
  1. Remove the underhood bussed electrical center (UBEC). Refer to Underhood Electrical Center or Junction Block Replacement .
  2. Remove the body wiring harness (1) /engine wiring harness (2) electrical connection clip from the UBEC bracket.

    3. Object Number: 1926986 Size: SH
  3. Remove the UBEC bracket bolt (1) and nuts (3).
  4. Remove the UBEC bracket (2) and reposition out of the way.

    5. Object Number: 1860397 Size: SH
  5. Disconnect the engine wiring harness electrical connector(s) (1) from the ignition coil(s) (4).

    6. Object Number: 860797 Size: SH
  6. Remove the ignition coil bolt(s).
  7. Remove the ignition coil(s).

Installation Procedure

    Object Number: 860797 Size: SH
  1. Install the ignition coil(s).

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the ignition coil bolt(s).

    3. Tighten
    Tighten the bolt(s) to 10 N·m (89 lb in).


    Object Number: 1860397 Size: SH
  3. Connect the engine wiring harness electrical connector(s) (1) to the ignition coil(s) (4).

    4. Object Number: 1926986 Size: SH
  4. Position and install the UBEC bracket (2).
  5. Install the UBEC bracket bolt (1) and nuts (3).

    6. Tighten
    Tighten the bolt/nuts to 10 N·m (89 lb in).


    Object Number: 1926984 Size: SH
  6. Install the body wiring harness (1) /engine wiring harness (2) electrical connection clip to the UBEC bracket.
  7. Install the UBEC. Refer to Underhood Electrical Center or Junction Block Replacement .