Special Tools

J 36660-A Torque Angle Meter

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Drain the engine coolant from the cooling system. Refer to Cooling System Draining and Filling.
3. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement.
4. Lower the vehicle.
5. Remove the lower intake manifold. Refer to Lower Intake Manifold Replacement.
6. Remove the exhaust crossover pipe. Refer to Exhaust Crossover Pipe Replacement.
7. Remove the thermostat bypass pipe. Refer to Thermostat Bypass Pipes Replacement.
8. Remove the right engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side.
9. Remove the oil level indicator tube. Refer to Oil Level Indicator and Tube Replacement.
10. Remove the engine left side spark plug wires from the spark plugs. Refer to Spark Plug Wire Replacement.
11. Remove the engine left side spark plugs. Refer to Spark Plug Replacement.
12. Remove the engine left side exhaust manifold. Refer to Exhaust Manifold Replacement - Left Side.



13. Remove the cylinder head bolts and discard the bolts.
14. Remove the cylinder head.



15. Remove the cylinder head gasket.
16. Clean the following areas:

•	The gasket sealing surfaces on the cylinder head, cylinder block, and intake manifolds

•	The cylinder block bolt threads

•	The cylinder head bolts

1. Install the cylinder head gasket.



2. Install the cylinder head.

Notice: Refer to Fastener Notice in the Preface section.




3. Install NEW cylinder head bolts.

Tighten
Tighten the bolts in sequence to 60 N·m (44 lb ft). Turn the bolts an additional 95 degrees using the J 36660-A .

4. Install the engine left side exhaust manifold. Refer to Exhaust Manifold Replacement - Left Side.
5. Install the engine left side spark plugs. Refer to Spark Plug Replacement.
6. Install the engine left side spark plug wires to the spark plugs. Refer to Spark Plug Wire Replacement.
7. Install the oil level indicator tube. Refer to Oil Level Indicator and Tube Replacement.
8. Install the right engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side.
9. Remove the thermostat bypass pipe. Refer to Thermostat Bypass Pipes Replacement.
10. Install the exhaust crossover pipe. Refer to Exhaust Crossover Pipe Replacement.
11. Install the lower intake manifold. Refer to Lower Intake Manifold Replacement.
12. Fill the engine with new engine oil. Refer to Engine Oil and Oil Filter Replacement.
13. Fill the cooling system with engine coolant. Refer to Cooling System Draining and Filling.