GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Venture Ext. 🢒 General Information 🢒 General Information 🢒 Engine Mount Strut Bracket Replacement - Right Side

Removal Procedure

    Object Number: 105887 Size: SH
  1. Remove the right engine mount strut from the right engine mount strut bracket. Refer to Engine Mount Strut Replacement - Right Side .

    2. Object Number: 190592 Size: SH
  2. Remove the engine oil cooler coolant line bracket bolt, if equipped.
  3. Remove the engine wiring harness bracket bolt.

    4. Object Number: 277918 Size: SH
  4. Remove the air conditioning compressor mounting bolts.
  5. Remove and set the air conditioning compressor aside.

    6. Object Number: 155767 Size: SH
  6. Remove the vertical engine mount strut bracket bolt from the right engine mount strut bracket.
  7. Remove the lower engine mount strut bracket bolt from the right engine mount strut bracket.
  8. Remove the right engine mount strut bracket.

Installation Procedure

    Object Number: 155767 Size: SH
  1. Position the right engine mount strut bracket over the pin locator.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the lower engine mount strut bracket bolt through the right engine mount strut bracket into the cylinder block.

    3. Tighten
    Tighten the engine mount strut bracket bolt to 50 N·m (37 lb ft).

  3. Install the vertical engine mount strut bracket bolt through the right engine mount strut bracket to the cylinder head.

    4. Tighten
    Tighten the engine mount strut bracket bolt to 50 N·m (37 lb ft).

  4. Install the air conditioning compressor. Refer to Air Conditioning Compressor Replacement in HVAC Systems with A/C - Manual.
  5. Install the engine wiring harness bracket bolt.

    6. Tighten
    Tighten the engine wiring harness bracket bolt to 13 N·m (110 lb in).


    Object Number: 190592 Size: SH
  6. Install the engine oil cooler coolant line bracket bolt , if equipped .

    7. Object Number: 105887 Size: SH
  7. Install the right engine mount strut to the right engine mount strut bracket. Refer to Engine Mount Strut Replacement - Right Side .