GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Disable the SIR system. Refer to Disabling the SIR System .
  2. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement in Doors.
  3. Peel the rear half of the water deflector away from the door in order to access the side impact sensor.

  4. Object Number: 742146  Size: SH
  5. Remove the screws that retain the side impact sensor (2) to the door.
  6. Disconnect the impact sensor electrical connector (1) from the side impact sensor.
  7. Remove the side impact sensor from the door.

Installation Procedure


    Object Number: 742146  Size: SH
  1. Position the side impact sensor (2) to the door.
  2. Connect the electrical connector (1) to the side impact sensor (2).
  3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the screws which retain the side impact sensor to the door.
  5. Tighten
    Tighten the side impact sensor screws to 8 N·m (71 lb in).

  6. Fully seat the water deflector to the door.
  7. Install the door trim panel. Refer to Front Side Door Trim Panel Replacement in Doors.
  8. Enable the SIR system. Refer to Enabling the SIR System .