- Remove the key from the
ignition.
- Connect the RF side impact module yellow 2-way connector (1)
located under the passenger seat.
- Install the connector position assurance (CPA) to the RF side
impact module yellow 2-way connector (2) located under the passenger
seat.
- Connect the LF side impact module yellow 2-way connector (1)
located under the driver seat.
- Install the CPA to the LF side impact module yellow 2-way
connector (2) located under the driver seat.
- Connect the IP module
yellow 2-way connector (1) located behind the main IP support.
- Install the CPA to the IP module yellow 2-way connector (1)
located behind the main IP support.
- Connect the steering wheel
module yellow 2-way connector (2) located at the base of the
steering column.
- Install the CPA (1) to the steering wheel module yellow 2-way
connector (2) located at the base of the steering column.
- Install the AIR BAG Fuse to the fuse block.
- Staying well away from all air bags, turn ON the ignition, with
the engine OFF.
| 11.1. | The AIR BAG indicator will flash 7 times. |
| 11.2. | The AIR BAG indicator will then turn OFF. |
- Perform the
Diagnostic System Check - SIR
if the AIR BAG indicator does not operate as described.
