GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2001 🢒 Prizm 🢒 General Information 🢒 General Information 🢒 Wheel Alignment Measurement

Steering and vibration complaints are not always the result of improper alignment. In order to diagnose a condition in the power steering system, refer to Diagnostic Starting Point - Power Steering System . In order to diagnose a condition in the steering wheel and column, refer to Diagnostic Starting Point - Steering Column . In order to diagnose a condition in the suspension, refer to Diagnostic Starting Point - Suspension General Diagnosis . In order to diagnose a vibration, refer to Diagnostic Starting Point - Vibration Diagnosis and Correction .

Before making any adjustment affecting wheel alignment, perform the following inspections and adjustments in order to ensure correct alignment readings:

    • Inspect the tires for the following conditions:
       - Pressure
       - Wear
       - Size
       - Brand
       - Construction
       - Balance
       - Runout
    • Inspect the runout of the wheels. Refer to Tire and Wheel Runout Specifications in Vibration Diagnosis and Correction.
    • Inspect the wheel bearings for runout. Refer to Hub/Axle Flange and Wheel Stud Runout Inspection in Vibration Diagnosis and Correction.
    • Inspect the wheel bearings for looseness. Refer to Wheel Bearings Diagnosis in Suspension General Diagnosis.
    • Inspect the following components for looseness or wear:
       - The front knuckles
       - The control arm ball studs
       - The control arm bushings
       - The outer tie rods
       - The inner tie rods
       - The steering gear
       - The stabilizer shafts
       - The strut assemblies
       - The upper strut mounts
    • Inspect the struts for leaks.
    • Inspect the vehicle trim height. Refer to Trim Height Inspection in Suspension General Diagnosis.
    • Inspect the remaining suspension and steering components for damage. Replace all damaged parts prior to adjusting wheel alignment.
    • Inspect the fuel level. The fuel tank should be full or the vehicle should have compensating ballast.

Give consideration to excess loads, such as tool boxes, sample cases, etc. If normally carried in the vehicle, these items should remain in the vehicle during alignment adjustments. Give consideration also to the condition of the equipment being used for the alignment. Follow the equipment manufacturer's instructions.

Satisfactory vehicle operation may occur over a wide range of alignment settings. However, if the setting exceeds the service allowable specifications, correct the alignment to the service preferred specifications. Refer to Wheel Alignment Specifications .

Perform the following steps to measure the front alignment angles:

  1. Install the alignment equipment according to the manufacturer's instructions.
  2. Perform the following procedure to normalize the suspension prior to measuring the angles:
    3. 2.1. Bounce the front bumper lightly 3 times.
    2.2. Bounce the rear bumper lightly 3 times.
  3. Measure the alignment angles.
  4. Record the readings. Make adjustments in the following order:
    5. 4.1. Rear toe

    Refer to Rear Toe Adjustment .

    4.2. Front camber

    Refer to Front Camber Adjustment .

    4.3. Front toe

    Refer to Front Toe Adjustment .