GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2009 🢒 Malibu 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Ignition Coil Replacement - Bank 1

Removal Procedure

    Object Number: 1839426 Size: SH
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.
  2. Disconnect the engine wiring harness electrical connectors (3) from the ignition coils.
  3. If removing the number 5 cylinder ignition coil, remove the evaporative emission (EVAP) canister purge tube. Refer to Evaporative Emission Canister Purge Tube Replacement.
  4. If removing the number one ignition coil, remove the canister purge solenoid. Refer to Evaporative Emission Canister Purge Solenoid Valve Replacement

    5. Object Number: 860797 Size: SH
  5. Remove the ignition coil bolts.
  6. Remove the ignition coils.

Installation Procedure

    Object Number: 860797 Size: SH
  1. Install the ignition coils.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the ignition coil bolts and tighten to 10 N·m (89 lb in).
  3. If the number 5 cylinder ignition coil was removed, install the EVAP canister purge tube. Refer to Evaporative Emission Canister Purge Tube Replacement.
  4. If the number one ignition coil was removed, install the canister purge solenoid. Refer to Evaporative Emission Canister Purge Solenoid Valve Replacement

    5. Object Number: 1839426 Size: SH
  5. Connect the engine wiring harness electrical connectors (3) to the ignition coils.
  6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement.