Schematic Reference: Audible Warnings Schematics

Did you perform the Audible Warnings Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Audible Warnings

Do any indicators illuminate when the chime sounds?

Go to Symptoms - Instrument Panel, Gages and Console

Go to Step 3

1. Turn the ignition OFF.
2. Remove the key from the ignition.
3. Turn the headlamp switch to OFF.
4. Open the driver's door.

Does the chime sound?

Go to Step 4

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

1. Install a scan tool.
2. Turn the ignition ON, with the engine OFF.
3. With a scan tool, perform the Chime Test in the Radio.

Does the chime stop when you select OFF?

Go to Step 5

Go to Step 10

With a scan tool, observe the Parklamp Switch parameter in the BCM Inputs data list.

Does the Parklamp Switch parameter display Inactive?

Go to Step 6

Go to Park Lamps Always On in Lighting Systems

With a scan tool, observe the Headlamp Switch parameter in the BCM Inputs data list.

Does the Headlamp Switch parameter display Inactive?

Go to Step 7

Go to Headlamp Low or High Beams Always On in Lighting Systems

1. Turn the ignition OFF.
2. Disconnect the BCM connector C3.
3. Install a scan tool.
4. Turn the ignition ON, with the engine OFF.
5. With a scan tool, observe the Key in Ignition parameter in the Body Control Module Inputs data list.

Does the Key in Ignition parameter display Inactive?

Go to Step 8

Go to Step 11

Test the key in ignition signal circuit for a short to ground. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 9

Replace the ignition switch. Refer to Ignition and Start Switch Replacement .

Did you complete the replacement?

Go to Step 12

--

Important: Perform the set up procedure for the replacement radio or multifunction alarm module (RPO).

Replace the radio or the multifunction alarm module (RPO). Refer to Radio Replacement in Entertainment or to Multifunction Alarm Module Replacement in IPC.

Did you complete the replacement?

Go to Step 12

--

Important: Perform the set up procedure for the replacement BCM.

Replace the BCM. Refer to Body Control Module Replacement in Body Control System.

Did you complete the replacement?

Go to Step 12

--

1. Use the scan tool in order to clear the BCM DTCs.
2. Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3