Driver Information Center Replacement UG1, EXC CF5

Important: The driver information center is serviced as part of the complete roof console.

1. Remove the roof console screw.



2. Use a small, flat-bladed tool in order to release the 2 retainers. These retainers are located on each side of the assembly in front of the switches. Press the retainers outward to release the roof console.



3. Lower the roof console from the headliner.
4. Disconnect the electrical connectors from the roof console.
5. Remove the roof console backing plate.
6. Remove the roof console.

Important: When installing the roof console, apply foam tape to the wiring harness. Secure the wiring harness in the proper position to the headliner.

1. Apply foam tape to the wiring harness at the headliner.
2. Install the roof console backing plate.
3. Connect the electrical connectors to the roof console.



4. Position the roof console to the roof console backing plate in the headliner.
5. Install the roof console by pressing the console into place until the retainers are completely engaged.

Notice: Refer to Fastener Notice in the Preface section.

6. Install the roof console screw.

Tighten
Tighten the screw to 2 N·m (18 lb in).

Driver Information Center Replacement CF5

Important: The driver information center is serviced as part of the complete roof console.

1. Remove the roof console screw.



2. Use a small, flat-bladed tool in order to release the 2 retainers. These retainers are located on each side of the assembly in front of the switches. Press the retainers outward to release the roof console.



3. Lower the roof console from the headliner.
4. Disconnect the electrical connectors from the roof console.
5. Remove the roof console.



6. Remove the sunshade anchors. Refer to Sunshade Anchor Replacement in Interior Trim.
7. Lower the headliner at the sunroof opening. Reach between the headliner and the roof to remove the foam tape from the wiring harness on the roof console backing plate. Refer to Headlining Trim Panel Replacement in Interior Trim.
8. Adjust the wiring harness for access.
9. Slide the roof console backing plate (2) forward and remove the backing plate from the front of the headliner.

1. Position the roof console backing plate (2) to the headliner opening.



2. Secure the wiring harness in the original position to the roof console backing plate.
3. Connect the electrical connectors to the roof console.



4. Install the headliner. Refer to Headlining Trim Panel Replacement in Interior Trim.
5. Install the sunshade anchors. Refer to Sunshade Anchor Replacement in Interior Trim.
6. Position the roof console to the roof console backing plate in the headliner.
7. Install the roof console by pressing the console into place until the retainers are completely engaged.

Notice: Refer to Fastener Notice in the Preface section.

8. Install the to the roof console screw.

Tighten
Tighten the screw to 2 N·m (18 lb in).