Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Remove the wiper arms. Refer to Windshield Wiper Arm Replacement .
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
3. Remove the wiper drive system module. Refer to Windshield Wiper System Module Replacement .

1

Windshield Wiper Motor Bolts (Qty: 3)

Tighten
6 N·m (53 lb in)

2

Windshield Washer Wiper Motor

Tip

1. Use the J 39232 Wiper Linkage Separator or equivalent to separate the transmission arm from the wiper motor crank arm pivot.
2. Use the J 39529 Wiper Linkage Installer or equivalent to install the transmission arm onto the wiper motor crank arm pivot.