Tonneau Ajar Indicator Always On. Chevrolet Corvette 2006

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2006 🢒 Corvette 🢒 Body 🢒 Wiring Systems 🢒 Tonneau Ajar Indicator Always On

Step	Action	Yes	No
Schematic Reference: Body Rear End Schematics
1	Did you review the Body Rear End description and operation and perform the necessary inspections?	Go to Step 2	Go to Luggage Compartment Description and Operation
2	Close the tonneau. Is the tonneau ajar indicator illuminated?	Go to Step 3	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems
3	Install a scan tool. Turn the ignition ON with the engine OFF. With a scan tool observe the Tonneau Ajar Switch Signal parameter in the body control module (BCM) Input Data 2 data list. Does the scan tool display open?	Go to Step 4	Go to Step 10
4	Disconnect the folding top lid latch. With a scan tool observe the Tonneau Ajar Switch Signal parameter in the BCM Input Data 2 data list. Does the scan tool display open?	Go to Step 5	Go to Step 7
5	Test for a short to ground in the signal circuit of the folding top lid latch ajar circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 11	Go to Step 6
6	Inspect for poor connections at the harness connector of the BCM. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 11	Go to Step 8
7	Inspect for poor connections at the harness connector of the folding top lid latch. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 11	Go to Step 9
8	Replace the BCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 11	--
9	Replace the rear compartment lid latches. Refer to Rear Compartment Lid and Fuel Filler Door Release Switch Replacement . Did you complete the replacement?	Go to Step 11	--
10	Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 11	--
11	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3