Schematic Reference: Starting and Charging Schematics

Connector End View Reference: Master Electrical Component List

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

Turn the ignition to the START position.

Does the starter solenoid click?

Go to Step 3

Go to Step 5

Did the engine crank and run?

Go to Symptoms - Engine Electrical

Go to Step 4

Did the engine crank, run and stall?

Go to Diagnostic Trouble Code (DTC) List - Vehicle

Go to Step 5

1. Turn OFF the ignition.
2. Disconnect the crank signal circuit to the starter solenoid.
3. Connect a test lamp between the crank signal circuit of the starter and a good ground.
4. Turn the ignition to the CRANK position.

Does the test lamp illuminate?

Go to Step 7

Go to Step 6

Test the control circuit of the starter solenoid for a high resistance or an open. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

System OK

Go to Step 9

Inspect for poor connections at the ignition switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

System OK

Go to Step 8

Inspect for poor connections at the starter solenoid. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

System OK

Go to Step 10

Replace the ignition switch. Refer to Ignition and Start Switch Replacement .

Did you complete the replacement?

Go to Step 11

--

Replace the starter motor. Refer to Starter Motor Replacement .

Did you complete the replacement?

Go to Step 11

--

Operate the system for which the symptom occurred.

Is the symptom still present?

Go to Step 2

System OK