For 1990-2009 cars only
Removal Procedure
- Remove the compact disc magazine if one is inserted in the compact disc changer by pressing the EJECT button.
- Remove the negative battery cable.
- Remove the floor console from the vehicle. Refer to Front Floor Console Replacement in Instrument Panel, Gauges and Console.
- Remove the compact disc changer cover retaining bolts.
- Remove the compact disc changer cover from the console.
- Remove the console wiring harness connector from the compact disc changer.
- Remove the compact disc changer retaining bolts.
- Remove the compact disc changer.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Slide the compact disc changer up and back toward the center of the console.
Installation Procedure
- Install the compact disc changer.
- Install the compact disc changer retaining bolts.
- Install the console wiring harness connector to the compact disc changer.
- Install the compact disc changer cover to the console.
- Install the compact disc changer cover retaining bolts.
- Install the floor console to the vehicle. Refer to Front Floor Console Replacement in Instrument Panel, Gauges and Console.
- Install the negative battery cable.
Slide the compact disc changer into place between the retaining tabs.
Tighten
Tighten the screws to 6 N·m (53 lb in).
Tighten
Tighten the screws to 1.9 N·m (53 lb in).
