Tools Required

1. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the power steering gear. Refer to Steering Gear Replacement .



4. Remove the starter motor. Refer to Starter Motor Replacement .
5. Install the EN 46326 .



6. Remove the crankshaft balancer bolt.



7. Place the remover pilot into the end of the crankshaft.
8. Install the J 41816 on the crankshaft balancer.



9. Remove the crankshaft balancer using the J 41816 .

Clean and inspect the crankshaft balancer. Refer to Crankshaft Balancer Cleaning and Inspection .

1. Position the crankshaft balancer on the nose of the crankshaft.



2. Press the crankshaft balancer in place using the J 41998-B .



3. Clean the crankshaft balancer bolt threads.
4. Apply engine oil to the crankshaft balancer bolt threads.

Notice: Refer to Fastener Notice in the Preface section.

5. Install the crankshaft balancer bolt.

5.1.	First Pass

Tighten
Tighten the crankshaft balancer bolt to 50 N·m (37 lb ft).

5.2.	Final Pass

Tighten
Tighten the crankshaft balancer bolt an additional 120 degrees using the J 45059 .




6. Remove the EN 46326 .
7. Install the starter motor. Refer to Starter Motor Replacement .
8. Install the steering gear. Refer to Steering Gear Replacement .
9. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
10. Lower the vehicle.
11. Install the drive belt. Refer to Drive Belt Replacement .