- Open the doors.
- Lower the windows.
- Remove the trim panel rear quarter. Refer to
Rear Quarter Trim Panel Replacement
in Interior Trim.
- Remove the garnish molding rear window . Refer to
Rear Window Garnish Molding Replacement
in Interior Trim.
- Disconnect the rear window defogger connectors at the window.
Caution: If a window is cracked but still intact, crisscross the window with
masking tape in order to reduce the risk of damage or personal injury.
Important: Before cutting out a stationary window, apply a double layer of masking tape
around the perimeter of the painted surfaces and inner trim of the window.
- Cover to protect the following parts from broken glass:
Caution: If broken glass falls into the defroster outlets, it can be blown into
the passenger compartment and cause personal injury.
| • | Defroster outlets and A/C outlets |
Caution: When working with any type of glass or sheet metal with exposed or rough
edges, wear approved safety glasses and gloves in order to reduce
the chance of personal injury.
Important: Keep the cutting edge of the tool against the window. This will allow the urethane
adhesive to be separated from the window. Leave a base of urethane on the pinchweld
flange. The only suitable lubrication is clear water.
- Use the J 24402-A
or J 39032
in order to cut the window from
the pinchweld flange. Keep the cutting edge of the tool against the glass.
Do this from inside the vehicle in order to protect the outer paint surface.
- Remove the window from the vehicle with
the aid of an assistant.
