The hazard and the turn signal flashers are part of the Hazard Switch assembly. If the hazard flasher or the turn signal flasher needs to be replace, it will require replacement of the Hazard Control Switch.

1. Remove the instrument panel right accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement - Right Side in Instrument Panel, Gages and Console.
2. Disconnect the electrical connector.



3. Remove the hazard switch by releasing the locking tabs.



4. Remove the hazard switch.

1. Press the hazard switch into the bezel until the locking tabs lock.



2. Connect the hazard switch electrical connector.
3. Install the instrument panel right accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement - Right Side in Instrument Panel, Gages and Console.