GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2007 🢒 Rendezvous - FWD 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Radio Replacement

Removal Procedure

    Object Number: 319664 Size: SH
  1. Remove the instrument cluster panel trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
  2. Remove the radio screws.

    3. Object Number: 319670 Size: SH
  3. Pull the radio away from the instrument panel (I/P).
  4. Disconnect the electrical/audio electrical connectors from the radio.
  5. Disconnect the coaxial cable connector from the radio.
  6. Remove the radio.

Installation Procedure

    Object Number: 319670 Size: SH
  1. Connect the coaxial cable connector to the radio.
  2. Connect the electrical/audio connectors to the radio.
  3. Install the radio to the I/P.

    4. Important: If the radio locator tab is difficult to align to the I/P locator opening, pull the radio toward you and reposition the antenna cable.

  4. Align the radio control locator tab to the I/P locator hole while carefully pressing the radio into the I/P until fully seated.

    5. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 319664 Size: SH
  5. Install the radio screws.

    6. Tighten
    Tighten the radio screws to 2.5 N·m (22 lb in).

  6. Install the I/P cluster trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
  7. Perform the radio set-up procedure. Refer to Control Module References for programming and setup information.