GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the knee bolster panel. Refer to Knee Bolster Replacement .

  2. Object Number: 771732  Size: SH
  3. Remove the driver information center (DIC) switch from the trim plate bezel. Refer to Driver Information Display Switch Replacement .
  4. Loosen the steering column bracket. Lower the steering column.
  5. Remove the trim plate bezel from the instrument panel cluster.

Installation Procedure


    Object Number: 771732  Size: SH
  1. Install the trim plate bezel. Press the bezel into place until seated.
  2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Tighten the steering column bracket nuts.
  4. Tighten
    Tighten the nuts to 24 N·m (18 lb ft).

  5. Install the DIC switch to the trim plate bezel. Refer to Driver Information Display Switch Replacement .
  6. Install the knee bolster panel. Refer to Knee Bolster Replacement .