Tools Required

J 38778 Door Trim Pad Clip Remover

1. Remove the power window switch (3), if equipped. Refer to Rear Side Door Window Switch Replacement .
2. Remove the arm rest pull cup cover (1).



3. Remove the armrest pull cup screws.
4. Starting at the door bottom, use the J 38778 to release the door trim panel retainers.
5. Lift the trim panel up to release the top edge and remove it from the door.

Important: Before installing the door trim panel to the door, discard the old trim panel retainers. Use new trim panel retainers in order to properly secure the trim panel to the door .

1. Install the new trim panel retainers to the trim panel.
2. Position the top of the trim panel at the window opening and press down.
3. Align the fasteners into the holes in the door metal.
4. Firmly press the door panel to seat the fasteners.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the armrest pull cup screws.

Tighten
Tighten the armrest pull cup screws to 2 N·m (18 lb in).

6. Install the armrest pull cup cover (1).
7. Install the power window switch (3). Refer to Rear Side Door Window Switch Replacement .