For 1990-2009 cars only
Removal Procedure
- Insert a plastic, flat-bladed tool at the front edge of the switch mounting plate. Press rearward to release the mounting plate retainer and lift up on the front of the plate.
- Lift the mounting plate and switch from the trim panel.
- Disconnect the electrical connector from the power window switch.
- Remove the switch from the mounting plate.
Important: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.
Notice: Apply protective coating/tape at the insertion point of the small flat-bladed tool in order to prevent damage to the inner door trim panel.
Installation Procedure
- Install the switch tabs into the mounting plate.
- Press down on the tabs in order to secure the switch.
- Connect the electrical connector to the window switch.
- Align the mounting plate to the door trim panel and press down to secure the retainer.
