Notice: Cap the fittings and plug the holes when servicing the fuel system in order to prevent dirt and other contaminants from entering the open pipes and passages.

Important: Always maintain cleanliness when servicing fuel system components.

1. Remove the fuel tank. Refer to Fuel Tank Replacement .
2. Note the position of the fuel, the evaporative emission (EVAP) pipes and the attaching hardware for installation.
3. Disconnect the fuel feed (2), the fuel return (2) and the EVAP pipe quick-connect fittings at the fuel sender assembly. Refer to Plastic Collar Quick Connect Fitting Service .
4. Cap the fuel sender fuel pipes and the in-pipe fuel filter pipes as needed to stop any fuel leakage.
5. Remove the fuel feed, the fuel return and the EVAP pipe attaching hardware.
6. Remove the fuel feed (2), the fuel return (2) and the EVAP pipes from the fuel tank.

Caution: In order to Reduce the Risk of Fire and Personal Injury: If nylon fuel pipes are nicked, scratched or damaged during installation, they must be replaced.

Notice: Always re-attach the fuel lines and fuel filter with all original type fasteners and hardware.

Notice: 

1. Install the new fuel feed (2), the fuel return (2) and the EVAP pipes to the fuel tank.
2. Install the fuel feed, the fuel return and the EVAP pipe attaching hardware.
3. Remove the caps from the in-pipe fuel filter pipes and the fuel sender fuel pipes.
4. Connect the fuel feed (2), the fuel return (2) and the EVAP pipe quick-connect fittings at the fuel sender assembly. Refer to Plastic Collar Quick Connect Fitting Service .
5. Ensure that all of the fuel pipe bundle clips, and fasteners are properly installed.
6. Install the fuel tank. Refer to Fuel Tank Replacement .