GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the 3 seat switch bezel screws. Refer to Driver Seat and Passenger Seat Adjuster Switch Bezel Replacement.

  2. Object Number: 752864  Size: SH
  3. Remove 4\ nuts that attach the seat pan to the seat assembly.
  4. Remove the clip from the front outboard seat pan stud. Discard the clip.
  5. Lift the seat pan up in order to allow access to the seat control module retaining screw.

  6. Object Number: 752957  Size: SH
  7. Remove the seat control module retaining screw.
  8. Disconnect the electrical connectors from the seat control module as necessary.
  9. Remove the seat control module from the seat assembly.

Installation Procedure

  1. Align and install the locating tabs on the seat control module with the seat pan.
  2. Connect the electrical connectors to the seat control module as necessary.
  3. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 752957  Size: SH
  4. Install the screw that retains the seat control module to the seat pan.
  5. Tighten
    Tighten the screw to 3 N·m (26 lb in).

  6. Install the seat pan to the seat assembly.

  7. Object Number: 752864  Size: SH
  8. Install the nuts which retain the seat pan to the seat assembly.
  9. Tighten
    Tighten the nuts to 25 N·m (18 lb ft).

  10. Install the 3 seat switch bezel screws. Refer to Driver Seat and Passenger Seat Adjuster Switch Bezel Replacement.
  11. Calibrate the seat. Refer to Memory Seat Calibration.
  12. Refer to Control Module References for programming and setup information.