GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Opel 🢒 1999 🢒 Sintra 🢒 Body and Accessories 🢒 Body Rear End 🢒 Liftgate Latch Replacement

Removal Procedure
  1. Open liftgate.
  2. Remove liftgate trim panel. Refer to Liftgate Trim Panel Replacement .

    3. Object Number: 313611 Size: LH
  3. Remove the liftgate latch retaining bolts.
  4. Disconnect the electrical connector from the liftgate latch.
  5. Remove the lock cylinder rod and latch cable from the liftgate latch.
  6. Remove the liftgate latch from the liftgate.

Installation Procedure

    Object Number: 313611 Size: LH
  1. Install the liftgate latch to the liftgate
  2. Install the lock cylinder rod and latch cable to the liftgate latch.
  3. Connect the electrical connector to the liftgate latch.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the liftgate latch retainer bolts.

    5. Tighten
    Tighten the retaining bolts to 10 N·m (89 lb in).

  5. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .