Circuit Description
The front left solar sensor provide the HVAC control module with inputs as to the amount of heat load the sun is placing on the interior of the vehicle. The solar sensor are photodiodes that are sensitive to light intensity. The HVAC control module applies 5 volts to internal input resistors that are connected to the front left signal circuits of the solar sensor. The HVAC control module provides ground to the sensors through the low reference circuit. The HVAC control module monitors the voltage drops across the solar sensor and converts the voltage values to count values where 1 volt is approximately equal to 51 counts. As the light intensity increases, the sun sensors allow more current to travel through the circuits and the signal voltages decrease. As the light intensity decreases, the solar sensor allow less current to travel through the circuits and the signal voltages increase.
DTC Descriptors
This diagnostic procedure supports the following DTC:
DTC B0183 Front Left Solar Sensor
Conditions for Running the DTC
Ignition is ON.
Conditions for Setting the DTC
| • | The HVAC control module determines that the value of the sun sensor parameter is less than 0.20V or greater than 4.64V. |
| • | The HVAC control module detects a short to battery positive voltage in the Solar sensor. |
| • | The HVAC control module detects that the Solar sensor control circuit is open. |
Action Taken When the DTC Sets
The Solar sensor value setting is 0.
Conditions for Clearing the DTC
| • | The DTC will become history if the HVAC control module no longer detects a fault. |
| • | Ignition is ON or OFF. |
| • | The DTC can be cleared with a scan tool. |
Test Description
The number(s) below refer to the step number(s) on the diagnostic table.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | |
2 |
Does the scan tool indicate that the Solar sensor parameter is within the specified range? | 0.27-4.64V | Go to Step 8 | Go to Step 3 |
3 |
Does the scan tool indicate that the Solar data parameter is greater than the specified value? | 4.64V | Go to Step 4 | Go to Step 5 |
4 |
Does the scan tool indicate that the Solar sensor value is less than the specified value? | 0.20V | Go to Step 8 | Go to Step 6 |
5 | Test the appropriate solar signal circuit of the Solar sensor for a short to ground. Did you find and correct the condition? | -- | Go to Step 12 | Go to Step 9 |
6 | Test the appropriate signal circuit of the Solar sensor assembly for a short to voltage, a high resistance, or an open. Did you find and correct the condition? | 2.2V | Go to Step 12 | Go to Step 7 |
7 | Test the low reference circuit of the Solar assembly sensor for a high resistance or an open. Did you find and correct the condition? | 2.2K ohms | Go to Step 12 | Go to Step 9 |
8 | Inspect for poor connections at the harness connector of the solar sensor assembly. Did you find and correct the condition? | -- | Go to Step 12 | Go to Step 10 |
Inspect for poor connections at the harness connector of the HVAC control module. Did you find and correct the condition? | 3.2-4.0V | Go to Step 12 | Go to Step 11 | |
10 | Replace the Solar sensor assembly. Did you complete the replacement? | -- | Go to Step 12 | -- |
11 | Replace the HVAC control module. Did you complete the replacement? | -- | Go to Step 12 | -- |
12 |
Does the DTC reset? | -- | Go to Step 2 | System OK |
