GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1795234  Size: SH
  1. Disconnect the negative battery cable.
  2. Disconnect the positive crankcase ventilation (PCV) hose from the air intake duct.
  3. Disconnect the air intake duct from the throttle body.

  4. Object Number: 1795371  Size: SH
  5. Retract the throttle body wiring connector lock (3).
  6. Disconnect the throttle body connectors by performing the following:
  7. • Do not use any mechanical device such as a screwdriver to disengage the harness connector from the throttle body.
    • When retracting the throttle wiring connector lock, take care not to disengage the lock from the connector.
    • Do not pull on the connector wires.
    • While pressing the connector latch in the direction of the arrow (4), disconnect the throttle body wiring connector.
    • Disconnect the throttle body connector.

    Object Number: 1823033  Size: SH
  8. Remove the four bolts, attaching the throttle body to the upper intake manifold.
  9. Remove the throttle body and gasket.

Installation Procedure


    Object Number: 1823033  Size: SH
  1. Ensure the throttle body and upper intake manifold mating surfaces are clean and free of foreign material.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the throttle body with a new throttle body to upper intake manifold gasket.
  4. Tighten
    Tighten the throttle body assembly attaching bolts to 10 N·m(89 lb in).

  5. Connect the wiring harness connector to the throttle body, ensuring the connector latch and connector slide have fully engaged.