GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Opel 🢒 2008 🢒 Antara 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Ignition and Start Switch Replacement

Removal Procedure


    Object Number: 1768899 Size: SH
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the steering column cover. Refer to Steering Column Trim Covers Replacement .
  3. Set the ignition key to ON position.
  4. Disconnect the electrical connector.
  5. Remove the ignition switch retaining screws.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1768899 Size: SH
  1. Install the ignition switch retaining screws.

    2. Tighten
    Tighten the ignition switch retaining screws to 2.5 N·m (22 lb in).

  2. Connect the electrical connector.
  3. Install the steering column cover. Refer to Steering Column Trim Covers Replacement .
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .