GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

1

  1. Disconnect inoperative door lock actuator motor electrical connector.
  2. Connect a test lamp between the inoperative door lock harness connector terminals A an B.
  3. Verify that the sliding door(s) are closed when diagnosing an actuator motor on a sliding door.
  4. While observing the test lamp, press either door lock switch to the UNLOCK position.

Does the test lamp flash once upon pressing UNLOCK?

--

Go to Step 3

Go to Step 2

2

  1. Connect a test lamp between inoperative door lock harness connector terminal A (terminal B on sliding door) and ground.
  2. While observing the test lamp, press either door lock switch to the UNLOCK position.

Does the test lamp flash once upon pressing UNLOCK?

--

Go to Step 4

Go to Step 5

3

Replace the inoperative door lock actuator motor.

Is the repair complete?

--

Go to Automatic Door Locks System Check

--

4

  1. Check door lock switch plate plungers and striker for good connection.
  2. If OK, repair poor connection or open in CKT 295.

Is the repair complete?

--

Go to Automatic Door Locks System Check

--

5

Repair poor connection or open in:

    • Driver's door lock: CKT 694.
    • Passenger door locks: CKT 294.
    • When diagnosing sliding doors actuator motors, check door lock switch plate plungers and striker for good connection.

Is the repair complete?

--

Go to Automatic Door Locks System Check

--