Step | Action | Value(s) | Yes | No | ||||
|---|---|---|---|---|---|---|---|---|
1 | Was the Headlamp System Diagnostic Check performed? | -- | Go to Step 2 | Go to Headlight System Check | ||||
2 |
Did the test lamp light? | -- | Go to Step 3 | Go to Step 4 | ||||
3 | Use a test lamp in order to backprobe between the underhood accessory junction block connector C2 terminal F8 and ground. Did the test lamp light? | -- | Go to Step 6 | Go to Step 5 | ||||
4 | Inspect for the following conditions in CKT 12 between the headlamp dimmer switch and C201 terminal E13:
Is there a faulty connection or an open in CKT 12? | -- | Go to Step 9 | Go to Step 10 | ||||
5 | Repair the following conditions in CKT 12 between C201 terminal E12 and the underhood accessory junction block harness connector C2 terminal F4:
Is the repair complete? | -- | Go to Headlight System Check | -- | ||||
6 | Use a test lamp to backprobe between the underhood accessory junction block connector C3 terminal B8 and ground, and terminal A8 and ground. Did the test lamp light at both terminals? | -- | Go to Step 7 | Go to Step 8 | ||||
7 |
Did the test lamp light at both connectors? | -- | Go to Headlamp Replacement | Go to Step 11 | ||||
8 | Replace the underhood accessory junction block. Refer to Relay/Fuse Center Replacement in Wiring Systems. Is the repair complete? | -- | Go to Headlight System Check | -- | ||||
9 | Repair a faulty connection or open in CKT 12. Is the repair complete? | -- | Go to Headlight System Check | -- | ||||
10 | Replace the headlamp dimmer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column-Tilt. Is the repair complete? | -- | Go to Headlight System Check | -- | ||||
11 |
Is the repair complete? | -- | System OK | -- |
