GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

1

Check the vehicle for Diagnostic Trouble Codes (DTCs).

Are there any DTCs present?

--

Go to Diagnostic Trouble Code (DTC) List in Engine Controls

Go to Step 2

2

Does the fuel gauge work?

--

Go to Step 3

Go to Instrument Cluster Indicators and Gauges Inoperative

3

  1. Disconnect the engine oil level indicator switch connector.
  2. Turn the ignition switch to the RUN position.
  3. Connect a (3 amp) fused jumper between the engine oil level indicator switch harness connector terminal A and ground.

Is the OIL LEVEL indicator on?

--

Go to Step 4

Go to Step 7

4

  1. Turn the ignition switch to the OFF position.
  2. Disconnect the PCM connector C2.
  3. Turn the ignition switch to the RUN position.

Is the OIL LEVEL indicator on?

--

Go to Step 5

Go to Step 6

5

  1. Check for a short to ground in CKT 1173.
  2. If OK, replace the instrument cluster. Refer to Instrument Cluster Replacement .

Has the repair been made and the system rechecked?

--

System OK

--

6

  1. Check for a poor connection or open in CKT 1174.
  2. If OK, replace the PCM. Refer to Powertrain Control Module Replacement/Programming in Engine Controls.

Has the repair been made and the system rechecked?

--

System OK

--

7

Connect a (3 amp) fused jumper between the engine oil level indicator switch harness connector terminals A and B.

Is the oil level indicator on?`

--

Go to Step 8

Go to Step 9

8

  1. Check for a poor connection at the engine oil level indicator switch connector.
  2. If OK replace the engine oil level indicator switch. Refer to Engine Oil Level Indicator Switch Replacement in Engine Controls.

Has the repair been made and the system rechecked?

--

System OK

--

9

Repair the poor connection or open in CKT 451 between the engine oil level indicator switch harness connector terminal B and G113.

Has the repair been made and the system rechecked?

--

System OK

--