GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

1

Inspect the vehicle for diagnostic trouble codes (DTCs).

Are any diagnostic trouble codes (DTCs) present?

--

Go to the Appropriate DTC Table

Go to Step 2

2

  1. Disconnect the generator connector.
  2. Install a fused (3 amp) jumper between the generator connector terminal B and ground.
  3. Turn the ignition switch to the RUN position.

Is the CHARGE warning ON?

--

Go to Step 3

Go to Step 4

3

Replace the generator. Refer to Generator Replacement

Is the repair complete?

--

Go to Charging System Check

--

4

  1. Disconnect the powertrain control module (PCM) connector 1.
  2. Install a fused (3 amp) jumper between the powertrain control module (PCM) connector C1 terminal 36 and ground.

Is the CHARGE warning ON?

--

Go to Step 5

Go to Step 6

5

  1. Inspect CKT 225 for an open between the PCM connector C2 terminal 61 and the generator connector terminal B.
  2. Replace the PCM if CKT 225 is OK. Refer to Powertrain Control Module Replacement/Programming

Is the repair complete?

--

Go to Charging System Check

--

6

  1. Backprobe a fused (3 amp) jumper between the underhood accessory wiring junction block connector C1 terminal F5 and ground.
  2. Turn the ignition switch to the ON position.

Is the CHARGE warning ON?

--

Go to Step 7

Go to Step 8

7

Repair the open in CKT 25 between the underhood accessory wiring junction block connector C1 terminal F5 and the PCM connector C1 terminal 36.

Is the repair complete?

--

Go to Charging System Check

--

8

  1. Backprobe a fused (3 amp) jumper between the underhood accessory wiring junction block connector C2 terminal A5 and ground.
  2. Turn the ignition switch to the ON position.

Is the CHARGE warning ON?

--

Go to Step 9

Go to Step 10

9

Replace the underhood accessory wiring junction block. Refer to Relay/Fuse Center Replacement

Is the repair complete?

--

Go to Charging System Check

--

10

  1. Backprobe a fused (3 amp) jumper between the instrument cluster connector C2 terminal K and ground.
  2. Turn the ignition switch to the ON position.

Is the CHARGE warning ON?

--

Go to Step 11

Go to Step 12

11

Repair the open in CKT 25 between the instrument cluster connector C2 terminal K and the underhood accessory wiring junction block connector C2 terminal A5.

Is the repair complete?

--

Go to Charging System Check

--

12

  1. Test the CHARGE warning bulb and the bulb connector.
  2. If the bulb and the bulb connector are OK, replace the instrument cluster. Refer to Instrument Panel (IP) Cluster Replacement

Is the repair complete?

--

Go to Charging System Check

--