Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Diagnostic System Check - Wiper/Washer

1. Disconnect the wiper motor connector C1.
2. Set the ignition switch to RUN.
3. Set the wiper switch to LO.
4. Connect a test light from connector C1, terminal F to ground.
5. Momentarily activate the washer switch while observing the test light.

Is the test light on when the washer switch is released?

--

Go to Step 3

Go to Step 4

Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle .

Is the replacement complete?

--

Go to Diagnostic System Check - Wiper/Washer

--

Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement .

Is the replacement complete?

--

Go to Diagnostic System Check - Wiper/Washer

--