GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2001 🢒 Intrigue 🢒 Body and Accessories 🢒 Wiring Systems 🢒 Temperature Valve Actuator Replacement - Left Side

Removal Procedure
  1. Remove the left instrument panel insulator. Refer to Instrument Panel Insulator Replacement in Instrument Panel Gauges and Console.
  2. Remove the knee bolster bracket. Refer to Knee Bolster Bracket Replacement in Instrument Panel, Gauges and Console.

    3. Object Number: 295297 Size: SH
  3. Disconnect the electrical connector from the left temperature actuator.
  4. Remove the mounting screws from the left temperature actuator.

    5. Object Number: 295301 Size: SH
  5. Remove the left temperature actuator.

Installation Procedure

    Object Number: 295301 Size: SH
  1. Position the left temperature actuator, then align the slots in the electric actuator driver to the flats on the temperature shaft.
  2. Align the locating hole to the alignment pin on the HVAC module cases.
  3. Slide the actuator driver on to the shaft. (The actuator driver should seat completely on to the shaft and the mounting holes should be flush with the mounting bolts on the HVAC module case

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the mounting screws to the left temperature actuator.

    5. Tighten
    Tighten the left temperature actuator screws to 1.5 N·m (13 lb in).


    Object Number: 295297 Size: SH
  5. Connect the electrical connector to the left temperature actuator.
  6. Install the knee bolster bracket. Refer to Knee Bolster Bracket Replacement in Instrument Panel, Gauges and Console.
  7. Install the left instrument panel insulator. Refer to Instrument Panel Insulator Replacement in Instrument Panel Gauges and Console.
  8. Recalibrate the actuator. Refer to Actuator Recalibration .