For 1990-2009 cars only
- Remove the instrument panel insulator. Refer to Instrument Panel Insulator Replacement in Instrument Panel, Gauges and Console.
- Press the brake pedal fully.
- Push the switches into the retainers until the switches are fully seated.
- Pull the brake pedal fully rearward against the pedal stop until you can no longer hear the audible clicks.
- Measure the brake pedal travel distances from the centerline of the brake pedal pad. Compare the measurements to the following values. The comparison of the values can verify that the cruise control release switch and the stop lamp switch are correctly adjusted:
- Install the instrument panel insulator. Refer to Instrument Panel Insulator Replacement in Instrument Panel, Gauges and Console.
Important: Adjust the cruise control release switch and the stoplamp switch together. Incorrect adjustment of either of these switches may cause premature brake lining wear or the incorrect operation of the cruise control system.
| • | The cruise control release switch and the stop lamp switch contacts must actuate at 3.5-12.5 mm (0.125-0.500 in) of brake pedal travel. |
| • | Nominal actuation of the stop lamp switch contacts occurs about 4.5 mm (0.2 in) beyond the point of cruise control release switch actuation. |
