GM Service Manual Online
For 1990-2009 cars only

SPEEDO WILL NOT FULLY RETURN TO ZERO (REPOSITION I/P SHIM)

SUBJECT: SPEEDOMETER WILL NOT FULLY RETURN TO ZERO - REPOSITION INSTRUMENT PANEL CARRIER SHIM

MODELS/YEARS: 1991-92 NINETY EIGHT AND 1992 EIGHTY EIGHT

CONDITION: Some 1991-92 Ninety Eight and 1992 Eighty Eight models may exhibit a condition where the speedometer will not fully return to zero when the vehicle has been brought to a full stop.

CAUSE: Pressure to the applique causes it to bubble and interfere with the speedometer cap.

CORRECTION:

----------- 1. Remove the cluster from the Instrument Panel.

2. Remove the 2.5mm (3/32 in.) shim from the Instrument Panel Carrier as shown in the illustration below. This shim is approximately 25mm (1 in.) wide and 50mm (2 in.) long.

3. Send the cluster to an AC/Delco Repair Center. (The applique must be changed in the cluster assembly.)

4. Reinstall the cluster.

5. Check the PRNDL cable routing as per Service Manual Section 8C.

6. Exercise the PRNDL cable.

7. If the PRNDL sticks or will not return to park, remove the cluster and glue the shim to the left cluster attachment as shown below.

8. Reinstall the cluster assembly.


Object Number: 88103  Size: MF

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.