GM Service Manual Online
For 1990-2009 cars only

You must replace any wheels which are bent, dented, or which have excessive lateral or radial runout. Wheels with runout greater than specified may cause objectionable vibrations.


    Object Number: 979  Size: SH
  1. Use a straight edge 203-229 mm (8-9 in) long. Place the straight edge on the wheel inboard mounting surface. Try to rock the straight edge up and down within the mounting surface.

  2. Object Number: 980  Size: SH
  3. Repeat this procedure on at least 3 or 4 different positions on the inboard mounting surface.
  4. • The outer ring of the mounting surface normally is raised above everything inside the mounting surface.
    • The mounting surface will be raised above the outer ring if the wheel mounting surface has been bent on a tire changer.

    Object Number: 981  Size: SH
  5. Inspect the mounting wheel/nut holes for damage caused from over-torquing the wheel nuts. Inspect for collapsed wheel/nut bosses. Inspect for cracked wheel bosses.

  6. Object Number: 980  Size: SH

    Notice: The use of non-GM original equipment wheels may cause:

       • Damage to the wheel bearing, the wheel fasteners and the wheel
       • Tire damage caused by the modified clearance to the adjacent vehicle components
       • Adverse vehicle steering stability caused by the modified scrub radius
       • Damage to the vehicle caused by the modified ground clearance
       • Speedometer and odometer inaccuracy

    Important: 

       • Replacement wheels must be equivalent to the original equipment wheels in the following ways:
          - The load capacity
          - The wheel diameter
          - The rim width
          - The wheel offset
          - The mounting configuration
       • A wheel of the incorrect size or type may effect the following conditions:
          - Wheel and hub-bearing life
          - Brake cooling
          - Speedometer/odometer calibration
          - Vehicle ground clearance
          - Tire clearance to the body and the chassis

  7. Replace the wheel if the wheel is bent.
  8. Replace the wheel if the wheel/nut boss area is cracked.

Identify steel wheels with a 2 or 3 letter code stamped into the rim near the valve stem. Aluminum wheels have the code, the part number, and the manufacturer identification cast into the back side of the wheel.