Starter Replacement 3.1L

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.




1. Disconnect the negative battery cable at the battery.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle Vehicle Lifting Caution in General Information.
3. Remove the lower closeout panel.
4. Remove the starter motor-to-engine bolts, then lower the starter.
5. Remove the electrical leads.
6. Remove the starter.

1. Install the starter.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Connect the leads to the starter.

Tighten
Tighten the cable to the solenoid 12 N·m (106 lb in)

3. Install the starter to the engine bolts.

Tighten
Tighten the bolts to 50 N·m (37 lb ft)

4. Install the lower closeout panel.
5. Lower the vehicle.
6. Connect the negative battery cable.

Tighten
Tighten the bolt to 16 N·m (12 lb ft)

Starter Replacement 2.4L

1. Disconnect the negative battery cable. Refer to

   Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

   in Cautions and Notices.
2. Remove the air inlet duct to the throttle body.



3. Remove the top starter bolt.
4. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
5. Remove the lower starter bolt.
6. Position the engine wiring harness aside.
7. Position the starter for access to solenoid wiring.
8. Remove the electrical wiring.
9. Remove the starter.

1. Install the electrical wiring.
2. Position the starter to the engine.
3. Install the lower starter bolt.
4. Reposition the engine wiring harness.
5. Lower the vehicle.
6. Install the top starter bolt.
7. Install the air inlet duct to the throttle body.
8. Install the negative battery cable.