For 1990-2009 cars only
Removal Procedure
- Apply the parking brake.
- Remove the master cylinder. Refer to Master Cylinder Replacement .
- Disconnect the vacuum hose from the vacuum booster and from the engine.
- Remove the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
- Remove the pushrod retainer (3) from the brake pedal pin (4).
- Remove the stop lamp switch (1) and the pushrod (2) from the brake pedal pin (4).
- Remove the vacuum booster mounting nuts.
- Remove the vacuum booster assembly.
- Remove the gasket.
Installation Procedure
- Install the gasket and the vacuum booster assembly.
- Install the vacuum booster mounting nuts on the vacuum booster.
- Position the stop lamp switch (1) on the pushrod (2) and install on the brake pedal pin .
- Install the pushrod retainer (3) to the brake pedal pin (4). The retainer will snap into place.
- Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
- Install the vacuum hose to the vacuum booster and to the engine.
- Install the master cylinder. Refer to Master Cylinder Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the vacuum booster mounting nuts to 40 N·m (30 lb ft).
