Removal Procedure
- Remove the radiator support diagonal brace if applicable. Refer to Radiator Support Diagonal Brace Replacement in Body Front End.
- Loosen the 3 air cleaner cover/resonator retaining screws (1).
- Remove the air cleaner cover/resonator (2).
- Lift the air cleaner element (6) and air outlet duct (3) from the lower air cleaner housing/washer solvent tank assembly (4).
- Remove the air cleaner element (6) from the air outlet duct (3) with a twisting and pulling motion.
- Inspect the entire assembly for dust, debris, or water. Clean or replace as necessary.
Installation Procedure
- Install the air cleaner element (6) onto the air outlet duct (3) with a twisting and pushing motion.
- Install the air cleaner element (6) and air outlet duct (3) into the lower air cleaner housing/washer solvent tank assembly (4).
- Install the air cleaner cover/resonator (2).
- Install the radiator support diagonal brace if applicable. Refer to Radiator Support Diagonal Brace Replacement in Body Front End.
Important: Ensure the air inlet duct (5) is properly positioned in the lower air cleaner housing/washer solvent tank assembly (4) before installing the air cleaner cover/resonator (2).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the 3 air cleaner cover/resonator retaining screws (1) to 4 N·m
(35 lb in).
