Removal Procedure
- Open the hood.
- Using a grease pencil, mark the location of the hinge on the hood assembly.
- Apply tape to the edges of the hood and the fenders to prevent any paint damage.
- Remove the hood assist rods (1). Refer to Hood Open Assist Rod Replacement .
- Remove the fasteners (2) securing the hood to the hood hinge.
- With the aid of an assistant, remove the hood from the vehicle.
Notice: When removing body panels, apply tape to corners of panel and adjacent surfaces to help prevent paint damage.
Installation Procedure
- With an assistant , position the hood to the vehicle.
- Align the hinge to the grease pencil marks on the hood.
- Install the fasteners (2) in order to secure the hood to the hood hinge.
- Install the hood assist rods (1). Refer to Hood Open Assist Rod Replacement .
- Adjust the hood, if necessary. Refer to Hood Adjustment .
- Remove the tape from the hood and the fenders.
- Using touch up paint, touch up any exposed or unpainted surface after the hood is installed.
- Close the hood.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fasteners (2) to 9 N·m (80 lb in).
