Engine Coolant Thermostat Replacement L47

Tools Required

J 38185 Spring Hose Clamp Pliers

1. Partially drain the cooling system. Refer to Cooling System Draining and Filling .
2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 4.0 L in order to gain access to the thermostat housing.
3. Position theJ 38185 to the clamp in order to remove the outlet radiator hose from the thermostat housing.



4. Remove the thermostat housing bolts.



5. Remove the thermostat and the thermostat housing gasket from the water pump housing.
6. Remove the thermostat housing from the water pump housing.

1. Install the new thermostat and gasket into the water pump housing.
2. Position the thermostat housing to the water pump housing.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the thermostat housing bolts.

Tighten
Tighten the thermostat housing bolts to 10 N·m (89 lb in).

4. Position theJ 38185 to the clamp in order to connect the outlet radiator hose to the thermostat housing.
5. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement in Engine Controls - 4.0 L.
6. Fill the cooling system. Refer to Cooling System Draining and Filling .