GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2003 🢒 Aurora 🢒 Engine 🢒 Engine Mechanical - 4.0L 🢒 Intake Camshaft Installation - Right Side

Tools Required

J 36660-A Torque Angle Meter

  1. Clean the camshaft journals, camshaft and the camshaft caps with a clean, lint-free cloth.

    2. Object Number: 734814 Size: SH
  2. Apply a liberal amount of lubricant GM P/N 12345001 (Canadian P/N 992704) or equivalent to the camshaft journals (1).

    3. Object Number: 880641 Size: SH
  3. Apply a liberal amount of lubricant GM P/N 12345001 (Canadian P/N 992704) or equivalent to the camshaft lobes (1) and the camshaft journals (2).

    4. Object Number: 734817 Size: SH

    Important: Ensure each valve rocker arm is properly aligned to the valve tip, the valve lifter and the camshaft lobe. Inspect the alignment prior to and after the camshaft caps are tightened to specifications.

  4. Place the camshaft in the camshaft carriers with the camshaft sprocket drive pins near the 45 to 60 degree location (1), clockwise from the top of their rotation and the camshaft lobes in a neutral position. The camshafts can be identified by a stamping near the rear journal. For example: L-EXH is defined as Left Bank Exhaust.

    5. Object Number: 721624 Size: SH
  5. Observe the markings on the camshaft bearing caps. Each camshaft bearing cap is marked in order to identify its location. The markings have the following meanings:
    6. • The arrow should point toward the front of the engine.
    • The number indicates the position from the front of the engine.
    • The "I" indicates the intake camshaft.
  6. Apply a liberal amount of lubricant GM P/N 12345001 (Canadian P/N 992704) or equivalent to the right intake camshaft bearing cap journals.

    7. Object Number: 880643 Size: SH
  7. Install the right intake camshaft bearing caps according to the identifications marks.
  8. Hand start all the right intake camshaft bearing cap bolts.

    9. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 734820 Size: SH

    Important: Ensure each valve rocker arm is properly aligned to the valve tip, the valve lifter and the camshaft lobe. Inspect the alignment prior to and after the camshaft caps are tightened to specifications.

  9. Install the right cylinder head intake camshaft bearing cap bolts.
    10. 9.1. First Pass

    Tighten
    Tighten the camshaft bearing cap bolts to 5 N·m (44 lb in).

    9.2. Final Pass

    Tighten
    Tighten the camshaft bearing cap bolts an additional 30 degrees using the J 36660-A .