Removal Procedure
- Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
- Peel back the water deflector far enough to access the door latch. Refer to Rear Side Door Water Deflector Replacement .
- Remove the inside door handle. Refer to Rear Side Door Inside Handle Replacement .
- Disconnect the outside door handle rod (1) from door latch by opening the clip (2).
- Remove the door latch fasteners.
- Remove the door latch (1) with the inside door handle and lock rods attached.
- Disconnect the electrical connectors.
Installation Procedure
- Install the electrical connectors.
- Install the door latch (1), with inside door handle and lock rods attached, into the door.
- Install the door latch fasteners.
- Connect the door handle rod (1) to the door latch.
- Install the inside door handle. Refer to Rear Side Door Inside Handle Replacement .
- Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fasteners to 10 N·m (89 lb in).
| 4.1. | Push the rod (1) upwards. |
| 4.2. | Insert the rod into the clip (2) on the door latch assembly. |
| 4.3. | Close the clip. |
Important: Inspect for the proper operation of the door handles before installing the water deflector and the door trim panel.
