Starter Replacement LX5

1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
3. Remove the lower air deflector. Refer to Front Air Deflector Replacement in Body Front End.
4. Remove the torque converter cover. Refer to Torque Converter Cover Replacement in Automatic Transaxle-4T65-E.



5. Disconnect the BAT cable from the starter solenoid.
6. Disconnect the wire from the "S" terminal on the starter solenoid.



7. Remove the 2 starter motor mounting bolts.
8. Remove the starter motor.

1. Install the starter motor.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the starter motor mounting bolts.

Tighten
Tighten the starter motor mounting bolts to 50 N·m (37 lb ft).




3. Connect the starter solenoid BAT terminal wire.

Tighten
Tighten the starter solenoid BAT terminal nut to 10 N·m (89 lb in).

4. Connect the starter solenoid "S" terminal wire.

Tighten
Tighten the starter solenoid "S" terminal nut to 3.4 N·m (30 lb in).

5. Install the torque converter cover. Refer to Torque Converter Cover Replacement in Automatic Transaxle-4T65-E.
6. Install the lower air deflector. Refer to Front Air Deflector Replacement in Body Front End.
7. Lower the vehicle.
8. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .

Starter Replacement L47

1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
2. Remove the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical-4.0 L.



3. Disconnect the BAT cable from the starter solenoid.
4. Disconnect the wire from the "S" terminal on the starter solenoid.



5. Remove the 2 starter motor mounting bolts.
6. Remove the starter motor.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Connect the starter solenoid "S" terminal wire.

Tighten
Tighten the starter solenoid "S" terminal nut to 4 N·m (35 lb in).

2. Connect the starter solenoid BAT terminal wire.

Tighten
Tighten the starter solenoid BAT terminal nut to 10 N·m (89 lb in).

3. Install the starter motor.
4. Install the starter motor mounting bolts.

Tighten
Tighten the starter motor mounting bolts to 30 N·m (22 lb ft).

5. Install the intake manifold. Refer to Intake Manifold Replacement in Engine Mechanical-4.0 L.
6. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .