For 1990-2009 cars only
- You may reattach the rear defogger bus bar lead wire or terminal by resoldering.
- Use a solder containing 3 percent silver and a rosin flux paste.
- Before soldering the bus bar, buff the repair area with fine steel wool. This removes the oxide coating formed during the glass manufacture.
- Use a brush in order to apply a paste-type rosin flux in small quantities to the following locations:
- Beforehand, coat the soldering iron tip with solder.
- DO NOT overheat the wire when resoldering the wire to the bus bar.
Notice: Use only enough heat to melt the solder. Using excessive heat can damage the rear window defogger components or the rear window.
| • | The wire lead |
| • | The bus bar repair area |
Use only enough heat in order to melt the solder. Use only enough solder in order to ensure a complete repair.
