INSUFFICIENT A/C COOLING (REPAIR TEMPERATURE DOOR). Oldsmobile Achieva 1992

*******************************************************************

REVISION 10/11/93

THIS BULLETIN IS BEING REVISED TO PROVIDE UPDATED PARTS INFORMATION AND CHANGE THE SERVICE PROCEDURE. *******************************************************************

SUBJECT: INSUFFICIENT A/C COOLING, TEMPERATURE DOOR NOT CLOSING IN FULL COLD (REPLACE TEMPERATURE DOOR CONTROL ARM)

MODELS: 1992 BUICK SKYLARK 1992 OLDSMOBILE ACHIEVA 1992 PONTIAC GRAND AM

IMPORTANT: PRIOR TO PERFORMING ANY SERVICE PROCEDURE RELATED TO AIR CONDITIONING LOW PERFORMANCE CONDITIONS, THIS PROCEDURE MUST BE COMPLETED FIRST.

CONDITION:

SOME OWNERS MAY COMMENT ON INSUFFICIENT AIR CONDITIONING COOLING, WHEN PRESSURES ARE WITHIN SPECIFICATIONS (REFER TO "V-5 TXV DIAGNOSTIC TEST", SECTION 1B IN APPLICABLE SERVICE MANUAL).

CAUSE:

HEATER - A/C TEMPERATURE DOOR MAY NOT BE CLOSING COMPLETELY, ALLOWING "WARMED" AIR TO BLEND WITH "COOLED" A/C DISCHARGE AIR.

CORRECTION:

FOR REPAIR, PERFORM THE FOLLOWING:

1. REMOVE RIGHT SIDE LOWER I/P INSULATOR TO GAIN ACCESS TO LOWER TEMPERATURE CONTROL CABLE.

2. REMOVE TEMPERATURE CONTROL CABLE FROM TEMPERATURE DOOR ARM (USE 7MM SOCKET TO PUSH THE RETAINING "FINGERS" TOGETHER TO ALLOW EASIER REMOVAL) AND UNSCREW END FROM CABLE.

3. REMOVE TEMPERATURE DOOR ARM RETAINER (GOLD COLORED) FROM CASE POST. REMOVE ARM AND DISCARD BOTH ARM AND RETAINER.

4. INSTALL NEW TEMPERATURE DOOR ARM FROM GM KIT, P/N 52466284, POSITIONING AS SHOWN IN ILLUSTRATION, USING NEW RETAINER (INCLUDED IN KIT). TO AID IN SEATING RETAINER, USE A SHORT 19MM - 3/8" SOCKET TO PUSH RETAINER ON.

5. INSTALL NEW WHITE COLORED TEMPERATURE CONTROL CABLE END TO CABLE, LEAVING 3 THREADS OF THE CABLE SHOWING OUTSIDE THE CABLE END (TOWARDS "EYELET").

6. INSTALL TEMPERATURE CONTROL CABLE TO ARM USING NEW PUSH-ON RETAINER. SEAT RETAINER FULLY ONTO ARM "PIN".

7. FIRMLY ROTATE CONTROL HEAD TEMPERATURE KNOB TOWARD "FULL HOT" UNTIL CLICKS ARE HEARD AND KNOB CANNOT BE ROTATED FURTHER.

8. REINSTALL INSULATOR PANEL.

EVALUATE SYSTEM PERFORMANCE AFTER REPAIR TO VERIFY THAT THE CONDITION HAS BEEN CORRECTED. IF PERFORMANCE IS STILL NOT ADEQUATE, FOLLOW "V-5 TXV DIAGNOSTIC PROCEDURE" AS GIVEN IN SECTION 1B OF THE APPLICABLE SERVICE MANUAL.

PARTS ARE EXPECTED TO BE AVAILABLE ON OCTOBER 18, 1993.

FOR VEHICLES REPAIRED UNDER WARRANTY, USE:

LABOR OPERATION NUMBER: D0580 TROUBLE CODE: 92

FIGURES: 1

Object Number: 81291 Size: FS

GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.