GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Holden 🢒 2009 🢒 WM Sedan 🢒 Preface 🢒 Cautions and Notices 🢒 Rear Window Wiper Arm Replacement

Removal Procedure

    Object Number: 2086736 Size: SH

    Important: Ensure the wiper arm is in the park position before commencing procedure.

  1. Lift the rear wiper arm cover (2) away from the rear window to access the rear wiper arm retaining nut (1).

    2. Object Number: 2094936 Size: SH
  2. Remove the rear wiper arm retaining nut (2) from the rear wiper pivot stud (1).
  3. Mark the position of the rear wiper arm (2) to the rear wiper pivot stud (1).
  4. Remove the rear wiper arm (3) from the rear wiper pivot stud (2).

Installation Procedure

    Object Number: 2094936 Size: SH
  1. Install the rear wiper arm (3) to the rear wiper pivot stud (2) making sure the marked location point is aligned.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the rear wiper arm retaining nut (2) to the rear wiper pivot stud (3).
  3. Tighten the rear wiper arm retaining nut (2).

    4. Tighten
    Tighten the nut to 9 N·m (80 lb in).


    Object Number: 2088976 Size: SH
  4. Push the rear wiper arm cover (2) down towards the rear window. Listen for an audible click to confirm fitting.
  5. Check the rear window wiper for correct operation and alignment.